For the last few hours in making the ident i had to
stop the 'great wall of china' photo being a 3d layer because the bdc logo on
it wouldn’t move in a diagonal motion across it. Instead as the layer was 3d
it was moving with the camera movement I had placed on it earlier and the bdc logo was
just moving across the picture from left to right. I researched on the Internet
how to make the logo go in a diagonal motion and it came up with making paths
and making the logo run along it.
I did make the
path but for some reason the logo wouldn’t run along it, I did this time and
time again making the logo 2d or 3d layer, doing the path then placing the logo on top of it or putting the logo on and drawing the path on it. Nothing worked. Instead I decided
to covert the ‘wall of china’ photo into a 2d layer and it stopped moving with
the camera movement it had. So I made the bdc logo a 3d layer and I managed to
make it move along the ‘wall of china’ photo using key frames.
No comments:
Post a Comment